What are the precautions for using high energy igniters? If you are not very familiar with it, then next, the editor will introduce it to you, hoping to help you.

1、 When using a touch wire to connect the ignition device and the electric nozzle, make sure that the electrodes on both sides of the cable are closely and reliably touched between the ignition device and the electric nozzle electrodes. Otherwise, it is likely to damage the electrode connection or ignition device.

2、 The step-down transformer has a unique design scheme for a time off and continuous working hour system. After a continuous tantrum for 30 seconds, it is important to terminate it for 60 seconds before striking again, otherwise it may cause damage to the ignition device components.

3、 It is prohibited to plug in the high-energy igniter when it refuses to connect the nozzle at the output port, as introduced by Xuzhou Jieneng Electric Power Equipment Co., Ltd. to prevent damage to components.

4、 The high-energy igniter is 20 joules and has a voltage of 2500 volts. It is important to have a good grounding system during installation.

5、 When the host power is connected, the normal status light should be on.

High energy igniters have many advantages, such as large flame kinetic energy, strong self-cleaning ability at the end of a tantrum, fast ignition, use of imported component nozzles, resistance to slagging, long service life, no harm from air pollution, and convenient application and maintenance.

Routine maintenance of high-energy igniters

1、 When the electric nozzle is not started, it is necessary to withdraw from the flame area to prevent its burning, deformation, or damage.

2、 Prevent the internal structure of the ignition device from water seepage or excessive moisture and cold, and timely clean up excessive dust accumulation.

3、 The conductive rod and electric nozzle are insulated with high aluminum porcelain, and it is prohibited to fall or collide to prevent damaging the insulating layer components and endangering the application.

4、 The surface layer of semiconductor material nozzle shall not be touched by hands during operation.

5、 In the event of a successful ignition, each power-on time should be reduced to increase the service life of the ignition device.